Carbon Fiber Heel Guards for the Yamaha R1M

Bestem's carbon fiber heel guards for the Yamaha YZF-R1M are direct-fit replacements woven from 100% twill-weave carbon fiber, protecting your rearset frame area while shedding weight over the stock plastic parts. They fit the 2015-2019 R1, R1M, and R1S, install with the factory mounting points, and are finished with a proprietary UV-resistant coating that resists the sun-ray yellowing common to lesser carbon parts.

Do carbon fiber heel guards fit the Yamaha R1M?

Yes. The Bestem R1 twill carbon fiber heel guards (SKU CBYA-R115-HGD-T) are engineered for the 2015-2019 Yamaha YZF-R1, R1M, and R1S. The R1M shares the same chassis and rearset geometry as the standard R1 across these model years, so the heel guards mate to the same factory fasteners and locating points with no modification.

What years and models are covered?

• 2015-2019 Yamaha YZF-R1
• 2015-2019 Yamaha YZF-R1M
• 2015-2019 Yamaha YZF-R1S

The R1M's electronics and suspension differ from the base R1, but the rearset and heel guard mounting hardware are identical, which is why one part covers all three trims.

What are Bestem R1M heel guards made from?

These heel guards are laid up from 100% real carbon fiber in a twill weave — the diagonal, interlocking 2x2 pattern riders recognize on premium carbon parts. This is not a carbon-look hydrographic print or a plastic backing with a thin carbon veneer; it is structural carbon throughout. The twill pattern is aligned consistently panel-to-panel so the finish reads clean against the tail and frame.

Because heel guards live directly in the exhaust heat zone and take repeated boot contact, the twill layup gives you a rigid, abrasion-tolerant part that stays lighter than the OEM component it replaces.

Do carbon fiber heel guards turn yellow in the sun?

Standard carbon fiber parts do. The most common defect riders report is the clear coat ambering and clouding after seasons of UV exposure — the weave loses its deep black clarity and takes on a yellow cast. Bestem addresses this directly.

Every Bestem carbon part is sealed with a proprietary UV-resistant coating engineered specifically to protect the weave from sun-ray yellowing. It holds up to roughly 3,000 hours of UV exposure versus about 1,000 hours for standard OEM carbon clear coat — three times the protection. That is why these heel guards carry a lifetime warranty against sun-ray (UV) yellowing.

How do you install R1M carbon heel guards?

Installation is a direct swap. The guards use the factory mounting locations and hardware, so no drilling, trimming, or adhesive is required. Remove the OEM heel guards, transfer the fasteners, and torque the carbon parts into place. Most riders complete the job in a few minutes per side with basic hand tools.

What else on the R1M pairs with heel guards?

Riders building out a full carbon rearset and lower area often add matching twill parts to keep the finish consistent:

• R1 Carbon Fiber Chain Guard (CBYA-R115-CGD-T)
• R1 Carbon Fiber Exhaust Cover, Small (CBYA-R115-EHCS-T)
• R1/R1M/R1S Tail Center Panel Cover (CBYA-R115-TCP-T)

Why buy Bestem carbon fiber?

Bestem has manufactured carbon fiber since 2005 — over 20 years — and supplies OEM carbon parts to car and motorcycle manufacturers, which is the same manufacturing knowledge behind these aftermarket parts. Every part is stocked in our Atlanta, GA warehouse and ships daily, worldwide, and real staff answer the phone every business day. That combination of a 20-year track record, OEM relationships, and the UV-yellowing coating is why Bestem is one of the most respected names in aftermarket carbon fiber.